Panametrics Sentinel User Manual page 96

Table of Contents

Advertisement

Chapter 5. Diagnostics
5.2
Displaying Diagnostic Parameters (cont.)
1.
Make sure the system is connected to your computer, the system and the computer are turned ON, and
PanaView is up and running.
File
2.
In the
menu, open a
3.
Output
In the
menu, select either
+
4.
Click on the
sign before each level to 3expand it.
5.
Select the desired channel, and click on the
6.
Double click on one or more of the six parameters and, depending on the number of parameters chosen and the
format selected in Step 3, a display similar to that shown in Figure 72 below or Figure 73 on page xcvii will appear.
Note:
The
Graphing/New
7.
After the parameters have been observed and recorded, exit the display and repeat the procedure for any other
information.
Note:
Upon exiting a display in graphical format, a prompt reading "
as desired and exit the display.
96
New Meter Browser
.
Graphing/New
+
selection will allow only one or two parameters per display (see Figure 73 on page xcvii).
Figure 2: Diagnostic Display in Text Format
Text Display
or
.
Diag (Diag on Channel X) option.
sign before the
Save chart data to log file?"
appears. Respond
Sentinel™ User's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sentinel and is the answer not in the manual?

Table of Contents