3.7
Configuring and Testing the Frequency Output
Unassigned Frequency on I/O
Use the PanaView
complete the steps in the following section.
3.7.1
Configuring the Frequency Output
1.
Make sure the system is connected to your computer, the system and the computer are turned on, and
PanaView is up and running.
2.
Under
File
open the
3.
Expand the drop-down menus until you access the meter and its submenus. Expand the last meter submenu,
Unassigned I/O
.
4.
Frequency 1
Double click on
Frequency Properties
5.
Under the
General
tab, locate the
Span
parameters.
6.
Frequency Unit
In the
Apply
and click on
. The window should look similar to Figure 53 below.
Sentinel™ User's Manual
menu to calibrate a Frequency Output. To access these menu options,
New Meter Browser
.
Frequency 2
or
, whichever is desired, then double-click on
window.
Input Settings
section, select the desired output for
Figure 12: Frequency Properties
section and enter the desired values for the
Channel
Sensor/Class
,
Chapter 3. Operation
Frequency
to bring up the
Min
Max
Zero
,
,
Unit
and
from drop-down menus,
and
73
Need help?
Do you have a question about the Sentinel and is the answer not in the manual?