Configuring The Analog Outputs; Calibrating The Analog Outputs - Panametrics Sentinel User Manual

3.6.1 Configuring the Analog Outputs (cont.)
5. Set the Zero and the
Sensor/Class and Unit
6. Errors
Next, click on the
from the drop-down menus. Then click on
3.6.2

Calibrating the Analog Outputs

After the configuration in the previous section is complete, proceed as follows to calibrate the analog outputs:
Sentinel™ User's Manual
Span to the desired values. In the
. Click on Apply . The window should look similar to Figure 49 below.
Figure 8: Recorder Properties
tab and select the Error Handling schemes for the
Apply
Figure 9: Recorder Errors
Recorder Unit section, select the desired output for
(see Figure 50 below).
Chapter 3. Operation
On Low Error On High Error
and
Channel
,
cases
71