3.7.2
Testing the Frequency Output
1.
Under the
General
tab, click on
2.
A window similar to Figure 55 below should appear, asking if you want to test the Frequency. Click on
3.
The screen should now look similar to Figure 56 below. Use the mouse to move the
Read the frequency value on the oscilloscope. The oscilloscope should read the
Percentage
pointer to 100%. Read the frequency off the oscilloscope. The oscilloscope should read the
4.
When you are done, press
Sentinel™ User's Manual
Test
.
Figure 14: Test Frequency Prompt
OK
Test Frequency
in the
Figure 15: Test Frequency Window
OK
window and then
in the
Chapter 3. Operation
Yes
Test Percentage
pointer to 0%.
Zero
value. Next, set the
Frequency 5 on Channel ...
.
Test
Span
value.
window.
75
Need help?
Do you have a question about the Sentinel and is the answer not in the manual?