3.12.3 Returning To Operation - Panametrics Sentinel User Manual

Table of Contents

Advertisement

Chapter 3. Operation
3.12.2 Using PanaView to Clear the Totalizers (cont.)
1.
Click on a totalizer to reset it (+ActMetTot in this example).
2.
Right click to bring up Properties.
3.
Click on Properties. The current total will be displayed (see Figure 68 below).
4.
Click the Reset button. The counter will be reset to 0.
5.
Click OK.
6.
Repeat the procedure for each totalizer in Channel 1, Channel 2, and Average to reset all totalizers.

3.12.3 Returning to Operation

1.
Verify that all totalizers have been cleared.
2.
Power down the electronics.
3.
Move the #8 DIP switch to the OFF (right) position.
4.
Power up the electronics and verify the operations, including the display board.
5.
Reapply a new lead and wire seal, if such security is needed, and reinstall the front cover.
88
Figure 27: Actual Metric Total Fwd on Average
Sentinel™ User's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Sentinel and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents