Ethernet Port Configuration; Table 6-18: Ethernet Status Indicators - Teledyne 200E Instruction Manual

Model 200E Instruction Manual
To initiate the test press the following key sequence.
SAMPLE
< TST TST > CAL
SETUP X.X
CFG DAS RNGE PASS CLK
EXIT returns
to the
SETUP X.X
previous
menu COMM VARS DIAG
Select which SETUP X.X
COM port to
ID COM1
test.

6.9.9. Ethernet Port Configuration

The optional Ethernet port (Section 5.7.3) communicates with the analyzer through the
COM2 serial port. Refer to Figure 3-2 and Figure 5-2 for location of this option. The Ethernet
board has two operational modes:
• Pass-through mode: This is the normal operation mode in which the board actively
passes data between the RS-232 port and the RJ-45 connector on the analyzer's rear
panel. This enables all remote commands to be passed to the analyzer.
• Configuration mode: The board stops passing data and is ready to accept and store
configuration parameters and firmware upgrades. The use of a terminal window or
separate configuration program is needed for these low-level configuration changes.
The iChip configuration utility is available at http://www.teledyne-api.com/software/
and provides a convenient, graphical user interface, which runs only on Microsoft
TM
Windows operating systems. All commands can also be issued via Terminal window
using the
AT+i
website along with other pertinent information.
The Ethernet board has four LEDs that are visible on the rear panel of the analyzer,
indicating its current operating status (Table 6-18).
LED
LNK (green)
ACT (yellow)
TA (green)
RA (yellow)
As soon as the Ethernet option is enabled in the COMM menu, a new sub-menu INET will
appear. This sub-menu is enabled by default when the analyzer was ordered with built-in
Ethernet and is used to set configuration parameters that enable the Ethernet card to
044100102 Rev A
RANGE = 500.0 PPB NOX =XXX.X
SETUP
PRIMARY SETUP MENU
MORE EXIT
SECONDARY SETUP MENU
EXIT
COMMUNICATIONS MENU
COM2 EXIT
Test runs
automatically
protocol. Instructions for

Table 6-18: Ethernet Status Indicators

ON when connection to the LAN is valid.
Flickers on any activity on the LAN.
Flickers when the RS-232 port is transmitting data.
Flickers when the RS-232 port is receiving data.
Operating Instructions
SETUP X.X COM1 MODE:0
SET> EDIT
SETUP X.X COM1 BAUD RATE:19200
<SET SET> EDIT
SETUP X.X COM1 : TEST PORT
<SET
TEST
SETUP X.X TRANSMITTING TO COM1
<SET TEST
commands are also available at the
AT+i
Function
EXIT
EXIT
EXIT
EXIT returns to
COMM menu
EXIT
81