Ozone Generator Override - Teledyne 200E Instruction Manual

Model 200E Instruction Manual
To activate the electrical test press the following keys.
SAMPLE RANGE = 500.0 PPB
< TST TST > CAL
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG
SETUP X.X
8 1 8

6.7.7. Ozone Generator Override

This feature allows the user to manually turn the ozone generator off and on. This can be
done before disconnecting the generator, to prevent ozone from leaking out, or after a
system restart if the user does not want to wait for 30 minutes during warm-up time. Note
that this is one of the two settings in the DIAG menu that is retained after you exit the
menu. To access this feature press the following keys. Also note that the ozone generator
does not turn on if the ozone flow conditions are out of specification (e.g., if there is no flow
through the system or the pump is broken).
SAMPLE RANGE = 500.0 PPB
< TST TST > CAL
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK
SETUP X.X SECONDARY SETUP MENU
COMM VARS
DIAG
SETUP X.X ENTER DIAG PASS: 818
8 1 8
044100102 Rev A
NOX=X.X
SETUP
MORE EXIT
EXIT
ENTER DIAG PASS: 818
ENTR EXIT
While the electrical test is
activated, PMT should equal:
2000 mV ± 1000 mV
NOX=X.X
SETUP
MORE EXIT
EXIT
ENTR EXIT
DIAG SIGNAL I / O
PREV NEXT JUMP
Press NEXT until...
DIAG ELECTRICAL TEST
PREV NEXT
DIAG ELEC RANGE = 500.0 PPB
<TST TST>
Press TST until...
DIAG ELEC PMT = 1732 MV
<TST TST>
DIAG SIGNAL I / O
PREV NEXT JUMP ENTR
Press NEXT until...
DIAG OZONE GEN OVERRIDE
PREV NEXT
DIAG OZONE OZONE GEN OVERRIDE
OFF
Operating Instructions
ENTR EXIT
ENTR EXIT
NOX=X.X
EXIT
NOX=X.X
EXIT
EXIT
ENTR EXIT
Toggle this key to
turn the O
3
ENTR EXIT
generator ON/OFF.
71