Table of Contents
Advertisement
Mutoh Ultima Multi-Purpose Cutting Plotter - Operation Instructions
Step 5 :
Put the hold lever in the DOWN position.
This action will initialize the media loading sequence, during which the cutter will measure the
loaded sheet. The sheet will be shuffled back and forth, enabling the cutter to determine the
media size and enabling you to verify the media transport.
Step 6 :
After finishing the media loading sequence, the tool head will be parked at the origin position and
the cutter will be in ON-LINE mode, ready to receive data from the host computer.
Notes :
Do not try to move the pressure rollers when the media hold lever is in the down
position as this may cause damage to the system.
2.8.2. Loading roll media
Step 1 :
Put the pressure rollers in the "up" position and turn the power switch ON.
The cutter will perform its initialization routine and move the tool head to the rightmost position.
Step 2 :
Press the media-select button on the operation panel and select the roll. After selection the
ROLL-LED will light up.
Step 3 :
Position the roll of media onto the conveyor rolls. Open the protective cover and pull the media
through to be able to choose the best possible position for the pressure rollers.
Notes :
Place the media roll on the conveyor rolls as visible on the picture.
To avoid back injuries, the roll of media should be lifted by at least two persons if it's
heavier than 30 kg.
20
AP-75125, Rev 1.3 ; 20/10/04
Hide quick links:
Advertisement
Table of Contents
