Nortel Communication Server 1000S Installation And Configuration Manual page 365

LD 73 — Defining PRI parameters and thresholds (Part 4 of 4)
Prompt Response
PERS ttt
CLRS ttt
OOSC nnn
LD 73 — Changing trunk pad category values (Part 1 of 2)
Prompt Response
REQ CHG
TYPE PRI2
FEAT PADS
PDCA #
The following prompts define the pad levels.
The receiving pad code is r and the transmission pad code is t. These entries have the range
0-15. The pad values (in decibels) relating to these codes are shown after this table.
ONP r t
DSET r t
OPX r t
DTT r t
SDTT r t
2.0 Mb PRI implementation
Description
Persistence Timer for Group II problems.
Enter 0-256 msec in increments of 2 msec. Default is 50
(=100ms).
Clearance Timer for Group II problems. Enter 0 - 256 msec in
increments of 2 msec. Default is 50 (=100ms).
Out-of-Service Counter.
Range for nnn of 0-255 with a default of 5.
Description
Change data.
2.0 Mb PRI.
PAD table-0 is default and is hard coded.
On-premises extension.
Meridian Digital set.
Prompted only if the 2.0 Mb Gateway feature is equipped.
Off-premises extension.
Digital TIE trunks.
Digital Satellite TIE trunks.
ISDN Primary Rate Interface
Page 365 of 394
Installation and Configuration