Nortel Communication Server 1000S Installation And Configuration Manual page 308

Page 308 of 394
LD 73 — Defining the 2.0 Mb DTI ABCD signaling bit tables (Part 2 of 8)
Prompt Response
N
FALT(R) abcd
N
Incoming Calls:
SEZ(R) abcd
SEZD(R) abcd
N
SEZV(R) abcd
N
P CALL(R) abcd
TIME ON OFF
SEZA(S) abcd
N
P WNKS(S) abcd
N
TIME 10-(220)-630
P DIGT(R) abcd
N
553-3001-201 Standard 2.00
2.0 Mb DTI implementation
Description
If FALT (send) signal not required.
(Receive) bits. 2.0 Mb DTI out-of-service.
If FALT (receive) signal not required.
Seize signal (send or receive) for voice or data calls from or
to a non-SL-1.
Seize signal (send or receive) for data calls between SL-1s.
If SEZD(R) signal not required.
Seize signal (send or receive) for voice calls.
If SEZV(R) signals not required.
(Receive) signal sent during seize by an incoming CO trunk.
Length of pulse time on, and time off.
(default 2 seconds on, 8 seconds off)
Seize signal acknowledgment (send).
If SEZA(S) signal not required.
Wink start (corresponds to a pulsed seize acknowledgment).
Prompted when SEZA(S) not required.
If WNKS(S) signal not required.
Time for WNKS(S) signal in milliseconds.
(Receive) decadic pulses.
If DIGT(R) not required.
September 2004