Page 352 of 394
Connect the cables
Figure 87
NTBK50 cabling
Small System
553-3001-201
Standard 2.00
2.0 Mb PRI implementation
Follow the instructions below to connect cables to the NTBK50 PRI card.
Also refer to Figure 87.
•
In the cabling area, located directly below the card cage, remove the
retaining bar that secures the MDF cables. Connect the NTBK05DA/CA
interface cable to the 50-pin Amphenol connector below the slot in which
the NTBK50 is installed. Re-install the retaining bar to secure the
cable(s) in place.
•
Terminate the NTBK05DA/CA carrier cable as required.
NTBK50
September 2004
NTBKO5AA
120½ Twisted Pair
NTBKO5CA
75½ Coax Pair
To 2.048
Mpbs Carrier
Cross Connect
553-AAA1073