Nortel Communication Server 1000S Installation And Configuration Manual page 356

Page 356 of 394
LD 17 — Adding a DCHI or DDCH (Part 2 of 3)
Prompt Response
CDNO 1-50
PORT 1
USR PRI
IFC xx
DCHL xx
PRI2 <CR>
OTBF 1-(16)-127
SIDE NET (USR)
553-3001-201 Standard 2.00
2.0 Mb PRI implementation
Description
Card slot number used as the primary DDCH/DCHI.
Card slots 10, 20, 30, 40, and 50 are only applicable for D-
channel configuration of ISL or VNS.
PORT set to "1".
D-channel is for ISDN PRI only.
Note: 2.0 Mb only supports PRI or SHA user mode.
Interface type.
PRI card number carries the D-channel. Must match entry
made for the "CDNO" associated with the "DCHI" prompt
above.
Where: xx = 1-9 for Option 11C main cabinet, 11-19 for IP
expansion cabinet 1, 21-29 for IP expansion cabinet 2, 31-
39 for IP expansion cabinet 3, and 41-49 for IP expansion
cabinet 4.
xx = 11-14, 21-24, 31-34, 41-44 of the first, second, third and
fourth MG 1000S, respectively.
Additional PRI Loops controlled by this DCHI. Remember
one DCHI can control up to 16 PRI loops going to the same
destination. For the system, the maximum limit is eight
loops.
Number of output request buffers. Note: for a single PRI link,
leave this prompt at default (16). Add 5 output request
buffers per additional link.
Prompted only if IFC is set to SL1.
NET = network, the controlling switch
USR = slave to the controller
September 2004