Nortel Communication Server 1000S Installation And Configuration Manual page 226

Page 226 of 394
Figure 72
ISL dedicated mode: using dial-up Hayes Smartmodem 2400
Large System
DCHI
R I P
500 set
R I P
card
TIE
R I P
Table 68
Active and stored profiles of the autodial or originating modem
Active profile:
B1 E0 L2 M1 Q1 V1 X4 Y0 &C1 &D0 &G0 &J0 &L0 &P0 &Q2 &R0 &S0 &X0 &Y0
S00:000 S01:000 S02:043 S03:013 S04:010 S05:008 S06:002 S07:030
S08:002 S09:006 S10:014 S12:050 S14:ACH S16:00H S18:000 S21:20H
S22:76H S23:15H S25:005 S26:001 S27:42H
553-3001-201 Standard 2.00
ISL installation
Originator
autodial
Modem
QCAD42
Twisted pair
Examples of parameters used for actual auto-answer and auto-dial sites are
shown in the following tables (note that the Hayes Smartmodem has been
used.) Table 68 on page 226
auto-dial site (or the originating modem). Table 69 on
active and stored profiles of the auto-answer site (or the terminating modem).
The Hayes Smartmodem User Guide contains explanations of the parameters
used in Table 68 and Table 69.
After the software parameters have been set up, the JP1 jumpers behind the
front faceplate of the Hayes Smartmodem must be dumb strapped on both
modems. Next, see the Hayes Smartmodem Getting Started Guide to set up
the hardware between the system and the modem.
September 2004
Terminator
autoanswer
Modem
ISL D-channel
shows the active and stored profiles of the
Large System
QCAD42
DCHI
PRI
Twisted pair
500 set
PRI
card
TIE
PRI
page 227
553-AAA0065
shows the