Nortel Communication Server 1000S Installation And Configuration Manual page 258

Page 258 of 394
Set switches on NTAK09 DTI/PRI card
Installing the NTAK09
553-3001-201 Standard 2.00
1.5 Mb PRI implementation
Set the switches on the NTAK09 DTI/PRI card according to Table 75.
Table 75
NTAK09 switch settings
Distance to digital
cross-connect
0 - 133 feet
133 - 266 feet
266 - 399 feet
399 - 533 feet
533 - 655 feet
Refer to Table 74 on
NTAK09 DTI/PRI circuit card appropriate to the system.
The NTAK09 DTI/PRI card is installed only in the MG 1000S. It is not
supported in the MG 1000S Expansion
Procedure 29
Installing the NTAK09
1 Check for available card slots in the base and expansion cabinets, and
MG 1000S systems and print the configuration record to determine which
slots can be used. To do this, enter the following command in LD 22:
PRT CFN
2 Hold the NTAK09 by the lock latch, unlock the latch, and slide the card
into the cabinet.
September 2004
1 2
DCH F/W (LEN 0)
Off Off
Off On
Off Off
Off On
Off Off
page 250 to determine the slot assignment for the
.
3 4
(LEN 1) (LEN 2)
Off On
On Off
On Off
Off Off
Off Off