Nortel Communication Server 1000S Installation And Configuration Manual page 262

Page 262 of 394
553-3001-201 Standard 2.00
1.5 Mb PRI implementation
This means that the D-channel is established and operational.
Procedure 33
Implementing basic PRI
Use this procedure to configure the PRI cards, DCHI interface, DCH link and
ISDN trunk route and trunks (B-channels) that are required to implement PRI
between systems. No feature applications other than Basic Call Service are
included in the implementation.
PRI cards must be configured before defining the DCH links or PRI
applications.
Prompts which do not show a response can be left as default. For more
information on any of these prompts, refer to Software Input/Output:
Administration (553-3001-311).
Before installing PRI cards in an IP expansion cabinet/MG 1000S, first
configure the expansion cabinet/MG 1000S for IP connectivity. Refer to
LD 117 in the Software Input/Output: Maintenance (553-3001-511) for further
information.
To implement PRI on the system:
1 Add a PRI card. See "Define clock synchronization. See "LD 73 —
Defining system timers and clock controller parameters" on page 270." on
page 262.
2 Add a DCHI card. See "LD 17— Adding a PRI card" on
3 Define a PRI customer. See "LD 15 — Defining a PRI customer" on
page 265.
4 Define a PRI service route. See "LD 16 — Configuring an ISDN service
route" on page
5 Define service channels (B-channels) and PRI trunks. See "LD 14 —
Defining service channels and PRI trunks" on
6 Define clock synchronization. See "LD 73 — Defining system timers and
clock controller parameters" on
September 2004
End of Procedure
268.
page
End of Procedure
page
page 269.
270.
263.