Nortel Communication Server 1000S Installation And Configuration Manual page 259

Note 1: Refer to Table 74 on
which to insert the card.
Note 2: For CS 1000S, the NTAK09 is installed only in the MG 1000S. It
is not supported in the MG 1000S Expansion.
Procedure 30
Connecting the cables
The only cable required to support the NTAK09 DTI/PRI circuit card is the
NTBK04 cable. The cable is twenty feet long. If additional distance is required,
the NT8D97AX fifty-foot extension is available up to a 600 foot maximum.
Table 76 on page 260
1 Connect the NTBK04 cable to a 50-pin Amphenol connector on the
cabinet.
For a Small System, the Amphenol connector is located below the card
slot in which the NTAK09 circuit card is installed.
For a CS 1000S system, the Amphenol connector is located on the rear
of the Media Gateway. The Amphenol connectors are labelled with the
card slot numbers to which they correspond.
2 Connect the other end of the cable to the CSU or DSX-1 cross connect.
ISDN Primary Rate Interface
1.5 Mb PRI implementation
page 250
End of Procedure
gives pinout information for the NTBK04.
Page 259 of 394
to determine the correct slot in
Installation and Configuration