Nortel Communication Server 1000S Installation And Configuration Manual page 288

Page 288 of 394
553-3001-201 Standard 2.00
1.5 Mb ISL implementation
Table 83
NTAK02 jumper settings
Unit Jumper location
Unit 0
Unit 1
Unit 2
Unit 3
Unit Jumper location
Unit 0
Unit 1
Unit 2
Unit 3
2 Install the NTAK02 in any available slot 1-10 of the Option 11C Cabinet or
slot 11-14 of MG 1000S 1.
Note: For CS 1000S, physical card slots are numbered 1-4 on the first,
second, third and fourth MG 1000S.
3 Install the NTAK19BA four-port cable on the 50-pin Amphenol connector
associated with the slot the NTAK02 is installed in.
4 If the installation is a dedicated mode using leased line modem
configuration, the D-channel connects the DCHI with the far-end modem
over a dedicated leased line. The modems must have a minimum
transmission rate of 2400 baud and must support leased line capability
and synchronous mode, 2-wire or 4-wire operation.
September 2004
Strap for DTE
J10 C - B
J7 C - B
J6 C - B
J5 C - B
J4 C - B
J3 C - B
—
J9
J8
—
J2
J1
Strap for DCE
B - A
B - A
B - A
B - A
B - A
B - A
RS422 RS232
—
C - B
C - B
—
C - B
C - B
—
B - A
B - A
—
B - A
B - A