Replacing The Compressor (From Appliance No. 15000) - Weinmann OXYMAT 3 Servicing And Repair Instructions

7.7 Replacing the compressor (from appliance no. 15000)

Tools required:
• Spanner set WM 14249,
• Allen key 6 mm.
• Hexagon socket wrench 8 mm,
• Water-pump pliers.
1. Open the housing (see "7.3 Opening the
appliance" on page 29).
2. Detach the compressor:
– Place the appliance on its back;
– Detach the compressor by using the socket
wrench to remove the 4 hexagonal nuts
with washer and spring washer
90
the underside of the chassis.
– Then stand the appliance upright again.
3. Loosen the straps
42
out of the fastener, and place them next to the
appliance.
4. Remove the front plate
– Tilt the front plate forwards and
– pull it out upwards.
The illustration opposite shows the installation
position of the compressor with its electrical and
pneumatic connections.
36
Repair information and repair instructions
92
from
91
, without pulling the strap
:
46
90
91
92
50
42
46
67