Weinmann OXYMAT 3 Servicing And Repair Instructions page 32

10. Place the two tubes
across the frame.
11. Then insert the compressor:
– Grasp the compressor in such a way that
you are able to read the letters on the
cylinder head the right way round.
– Insert the front screws of the compressor into
the vibration damper
– Tilt the compressor into the appliance.
Make sure that the compressor is securely and
safely positioned.
12. Slide the capacitor
49
foam section and lay the cables neatly into
43
the groove.
13. Connect tube to the inlet and tube
70
outlet of the compressor.
14. Attach the connector of the compressor to the
power supply socket and lay the cables neatly
into the groove.
15. Check that the compressor is positioned in the
appliance the right way round, i.e. with the
inlet pointing to the right:
– Connect the power cord
appliance and to a socket.
– Switch on the appliance.
– Feel from which side of the compressor air
is being drawn in. This side is the inlet. It
must be on the right.
16. Check that all cables are laid correctly in the
groove.
17. Place the lower edge of the front plate
the frame and tilt it against the foam section
18. Place the straps over the foam sections and
42
tighten them.
32
Repair information and repair instructions
and sideways
51 70
.
60
into the opening of the
to the
51
to the
10
into
46
45
– Switch off the appliance and pull the power
cord from the socket and from the
10
appliance.
– If the inlet of the compressor is on the left-
hand side, re-install the compressor.
.
70
60
43
49
51
70
51
45
46