Replacing The Fan - Weinmann OXYMAT 3 Servicing And Repair Instructions

7.10 Replacing the fan

Tools required:
• Spanner set WM 14249,
• Allen key 6 mm.
1. Open the appliance (see "7.3 Opening the
appliance" on page 29).
2. Loosen the straps
42
out of the fastener, and place them next to the
appliance.
3. Remove the front plate
– Tilt the front plate forwards and
– pull it out upwards.
4. Lift up the foam section
operating panel and pull out the defective fan
.
52
5. Pull the connector off the fan.
6. Take a new fan and push the connector
52
onto the contacts.
7. There are two arrows on the edge of the fan
showing the direction of air flow. As you want
the air to be drawn in and expelled to the
compressor, it is important to hold the fan so
that the
arrow is pointing downwards
8. Lift up the foam section
operating panel and insert the fan
arrow pointing downwards)
9. Place the cable into the groove in the foam
section .
43
10. Before assembling the appliance, please
subject the fan to a test run:
– Connect the power cord
appliance and to a socket.
– Switch on the appliance.
– Check the function of the fan:
Never reach into the fan!
With your hand held flat, place it between
the fan and the compressor and feel the air
flow.
42
Repair information and repair instructions
, without pulling the strap
:
46
together with the
45
.
together with the
45
(with the
.
to the
10
42
46
45
43
52