Table of Contents
Advertisement
7.5 Replacing the fascia film
Tools and equipment required:
•
Allen key 3 mm,
•
ESD workplace,
•
Phillips screwdriver size 1,
•
Knife with smooth, flat blade.
1. Open the device (see "7.2 Opening the
device" on page 23).
2. Remove the Displayboard (see "7.4 Replace
Displayboard" on page 25, steps
3. Detach fascia film with a knife blade and pull
off carefully.
Degrease this area of the housing with a little
70%-strength isopropanol.
4. Remove the protective film from the inside of the
new fascia film and stick the fascia film
/
to the appropriate part of the housing.
38
39
Take care when inserting the ribbon cable
through the opening in the housing; it must be
properly routed without any kinks.
5. Using your finger nail, carefully remove the
outer protective flim from the new fascia film.
6. Fit the Displayboard (see "7.4 Replace
Displayboard", steps
7. Close the device (see "7.3 Closing the
device" on page 24).
8. Perform a test (see "5. Test the device" on
page 15).
7.6 Changing fuses on the Powerboard
Tools and equipment required:
•
Allen key 3 mm,
•
ESD workplace.
1. Open the device (see "7.2 Opening the
device" on page 23).
2. Carefully lift the Powerboard
Smartboard
/
or Softboard
51
52
26
Repair Information and Instructions
to
).
3.
5.
/
37
to
).
6.
8.
and
47
slightly.
53
Ribbon cable
Advertisement
Table of Contents
