Weinmann OXYMAT 3 Servicing And Repair Instructions page 58

6. Place one arm around the entire foam
sections.
7. With the other arm, support yourself against
the frame and lift up the foam sections
(including ADS containers, oxygen tank,
cooler, fan and operating panel).
Note:
If two people are working together, one of you
can lift up the foam sections with both arms whilst
the other holds the frame steady.
8. Position the new frame
label) on the castors.
9. Insert the foam sections into the frame.
10. Place the appliance connector
groove of the frame.
11. Push the exhaust damper
as possible and secure it to the frame with two
cable ties .
65
12. Align all parts, such as ADS containers and
oxygen tank.
13. Check that the cables and tubes are laid in the
groove on the foam section. If necessary,
press them in.
14. Place the foam section
Note:
Check that both foam pads 88 are in place.
15. Install the compressor (see "7.5 Replacing the
compressor (up to appliance no. 13350)" on
page 30, steps
10.
16. Place the lower edge of the front plates
the frame and tilt it against the foam section
17. Place the straps over the foam sections and
42
tighten them.
18. Before assembling the housing, subject the
appliance to a test run:
– Connect the power cord
appliance and to a socket.
– Switch on the appliance.
You should not hear any unusual noises,
such as rattling and slipping.
– Switch off the appliance and pull the power
cord from the socket and from the
10
appliance.
19. Close the appliance (see "7.4 Closing the
appliance" on page 30).
20. Perform a functional check (see "5. Functional
check" on page 10).
58
Repair information and repair instructions
(with appliance
58
into the
59
backwards as far
66
in position.
44
to ).
16.
into
46
45
to the
10
44
88
42
.
65
66
59
58
45
46