Towing The Machine - With Tow Valve - Volvo Ingersoll Rand SD-116 TF Series Operator's Manual

SECTION 4
6. Place a wrench on the middle size hex (3, Figure 4-31 & Figure 4-32) and a
second wrench on the large hex (4) to prevent cartridge rotation. Rotate the
middle size hex three revolutions clockwise (CW) to close the bypass valve.
7. Lower the operator's platform. See page 4-19.
8. TURN ignition key to the "ON" position, pull the emergency stop up, and verify
the park brake switch is illuminated to indicate the parking brake is applied.
9. Check the parking brake using the parking brake test switch procedures
identified in Section 5 of these instructions
10. Close the hood of the engine compartment.

TOWING THE MACHINE - WITH TOW VALVE

Machine runaway condition could occur.
Always chock the drum and wheels of a disabled machine or hitch it to its
towing vehicle to prevent accidental movement while preparing the
machine for towing.
This is especially important if machine failure occurs on an incline.
4-26
Figure 4-32
WARNING
!
SD-116F/DX/122D/F/DX/160F/DX/190DX/200F/DX
OPERATING INSTRUCTIONS