Drain And Clean Hydraulic Tank And Three Hydraulic Suction Strainers - Volvo Ingersoll Rand SD-116 TF Series Operator's Manual

MAINTENANCE INSTRUCTIONS

Drain and Clean Hydraulic Tank and Three Hydraulic Suction Strainers

Hot oil or components can burn.
Oil must be at normal operating temperature when draining.
Avoid contact with hot oil or components.
Do not allow oil to drain into the ground.
Dirt in the hydraulic system will lead to premature component failure.
A clean, contaminant-free system is extremely important to the machine's
proper function.
Take extra care when working around or on the hydraulic system to
ensure its complete cleanliness.
1. Position the compactor on level ground, allowing machine to run sufficiently so
hydraulic oil reaches operating temperature.
2. After properly positioning the machine, shut down the engine and apply brake.
3. Place a container with a capacity of at least 85 liters (23 gallons) under the
hydraulic tank drain point (1, Figure 5-82) to capture the oil.
SD-116F/DX/122D/F/DX/160F/DX/190DX/200F/DX
WARNING
!
NOTICE
Figure 5-82
SECTION 5
5-69