Check Drum Drive (Torque Hub) Oil Level - Sd-200 Tf - Volvo Ingersoll Rand SD-116 TF Series Operator's Manual

SECTION 5

Check Drum Drive (Torque Hub) Oil Level - SD-200 TF

The SD-200 TF drum drive assembly is equipped with a single fill and drain hole equipped with
a spring loaded cap. The fill/drain hole rotates with the drum. It must be positioned at the 12
o'clock position to add oil and at the 6 o'clock position to drain oil with the use of a clear
standpipe supplied with the SD 200. Access to the spring loaded can is thru access holes in
the drum drive mounting bracket.
1. Park the machine on a level surface with the single drain/fill port on the drive
aligned with access hole (1, Figure 5-43)
2. Allow drive motor case to cool if necessary.
3. Remove one of the two hex allen head oil fill/level check plugs (2, Figure 5-43),
located at the 9 o'clock position or (1, Figure 5-44) located at the 3 o'clock
position.
4. Check oil level. Verify that oil is level with bottom of level check hole.
5-40
MAINTENANCE INSTRUCTIONS
Figure 5-42
Figure 5-43
SD-116F/DX/122D/F/DX/160F/DX/190DX/200F/DX