Adjust And Set Valve Clearance; Change Drum Drive (Torque Hub) Oil Level - Sd 116, 122, 160 And 190 - Volvo Ingersoll Rand SD-116 TF Series Operator's Manual

MAINTENANCE INSTRUCTIONS

Adjust and Set Valve Clearance

Refer to the engine manual for maintenance instructions. This operation requires a trained
service engineer.

Change Drum Drive (Torque Hub) Oil Level - SD 116, 122, 160 and 190

1. Park machine on level ground apply park brake.
2. Allow drive motor case to cool if necessary.
3. Remove the allenhead oil level check plug, (1, Figure 5-84) located at the 4
o'clock position.
4. Position a container under the torque hub.
5. Remove drain plug at the 6 o' clock location and allow oil to drain.
6. Clean and replace drain plug.
7. Remove fill plug (1, Figure 5-85) and add oil until oil is level with bottom of oil
level check plug location (1, Figure 5-84).
8. Clean and replace plugs. Wipe up any excess oil.
SD-116F/DX/122D/F/DX/160F/DX/190DX/200F/DX
Figure 5-84
SECTION 5
5-71