Volvo Ingersoll Rand SD-116 TF Series Operator's Manual page 77

OPERATING INSTRUCTIONS
3. Place high/low engine speed switch (13, Figure 4-16) in the high position.
4. Release the park brake by pushing inward on the lower portion of the switch
(15, Figure 4-16). Observe that the switch indicator light goes out.
NOTE: Operator must be seated when Park Brake is released or engine will
stop after approximately two seconds.
5. The High
selector switch (14, Figure 4-16) prior to moving the machine.
• The High speed range should only be used when traveling between work sites.
• The Low speed range should always be used when compacting, or traveling
inclined surfaces.
• Do not shift speed range switch at speeds above 5 km/h (3 m.p.h.).
6. Press and hold release pushbutton (17, Figure 4-17) and slowly move
propulsion control (19) in desired direction and safe speed of travel as
determined by the conditions. The further the control is moved from the STOP
position the greater the speed in that direction.
SD-116F/DX/122D/F/DX/160F/DX/190DX/200F/DX
Figure 4-16
or Low speed range must be selected on the speed range
SECTION 4
4-13