Check Wheel Ends Oil Levels - Volvo Ingersoll Rand SD-116 TF Series Operator's Manual

SECTION 5
2. Look at the sight gauge (3, Figure 5-35) and verify the oil is to the center of the
gauge. If additional oil is required, remove fill plug (1, Figure 5-34) and add oil
as required until oil is centered in the gauge. Refer to Section 8 for oil
specifications.
3. Install plug (1, Figure 5-34) and wipe up excess oil.

Check Wheel Ends Oil Levels

1. Park the machine on a level surface with the wheel end oil level check plug (1
Figure 5-36) located in the 9 o'clock (2) or the 3 o'clock (3) position and shut off
engine.
2. Allow wheel end to cool if necessary.
3. Clean around plug and remove.
4. Verify oil level is at the bottom of level hole.
5. If not, add oil until level with hole. Refer to Section 8 for oil specifications.
5-36
MAINTENANCE INSTRUCTIONS
Figure 5-35
Figure 5-36
SD-116F/DX/122D/F/DX/160F/DX/190DX/200F/DX