Replace In-Line Fuel Filter - Tier 2 Engines - Volvo Ingersoll Rand SD-116 TF Series Operator's Manual

MAINTENANCE INSTRUCTIONS
6. Install the filters and tighten each filter one quarter turn beyond seal contact.
7. Start the engine and check for leaks.
8. Wipe up any excess oil.
9. Close cover and bolt.

Replace In-Line Fuel Filter - Tier 2 Engines

Fuel is flammable. May cause severe injury or death.
Shut down the engine, extinguish all open flames and do not smoke while
filling the tank.
Always wipe up any spilled fuel.
The in-line fuel filter will eventually clog from accumulated sediment. To
prevent this, the in-line fuel filter must be replaced at the same time that
the primary fuel filter is changed. Perform the steps outlined below to
replace the in-line fuel filter.
1. Park machine on a stable, level surface and shut down the engine (1, Figure 5-
58).
2. Open the hood and locate the filter
3. Position a container under the in-line filter to catch the residual fuel that will
escape from the old filter when it's disconnected.
4. Disconnect the fuel line from each side of the in-line filter. Pinch off the lines to
stop the flow of fuel from the open lines.
SD-116F/DX/122D/F/DX/160F/DX/190DX/200F/DX
WARNING
!
Figure 5-58
SECTION 5
5-49