OPERATING CONTROLS AND INSTRUMENTS
LOW OIL PRESSURE INDICATOR
The low oil pressure indicator light (27) turns on to indicate the engine has low oil pressure.
This light also turns on when the ignition key is turned to the On position. If this indicator turns
on during normal operation, shutdown the engine immediately and notify service personnel.
AIR FILTER RESTRICTED INDICATOR
This indicator light (28) comes on when the key is turned to the On position. The light also
comes on to indicate that the air cleaner filter elements require service.
GRID HEATER INDICATOR (REF. ONLY)
The indicator (29) illuminates with the Ignition switch in the Run position when the engine
temperature is below starting temperature.
Do not use ether. Intake manifold glow heater starting aid has a high
temperature element. Ether may cause explosion and severe injury.
Starting aids are extremely flammable and can explode
The illuminated light indicates that the grid heater is heating the air in the engine air intake
chamber. The indicator will go out when the air intake temperature is high enough to assist in
starting the engine.
TURN SIGNAL INDICATORS
The turn signal indicators (30) show the direction in which the machine is going to turn on
machines equipped with optional turn signals.
CHECK ENGINE LIGHT (AMBER)
Amber light (31) will illuminate when engine sensors detect areas of concern which should be
investigated by the maintenance personnel
STOP ENGINE LIGHT (RED)
As stated on light (32) the operator is advised to STOP the engine as soon as possible
following all safety precautions. An illuminated light indicates serious areas of concern.
HYDRAULIC OIL TEMPERATURE INDICATOR
This indicator (33) illuminates if the hydraulic oil temperature is too high. This light also turns
on when the ignition key is turned to the On position If the indicator turns on during normal
operation, shutdown the engine immediately and notify service personnel to investigate the
cause.
SD-116F/DX/122D/F/DX/160F/DX/190DX/200F/DX
WARNING
!
SECTION 3
3-9