Propelling Machine And Other Checks/Verifications; While Engine Is Running - Volvo Ingersoll Rand SD-116 TF Series Operator's Manual

SECTION 4
8. Press the horn button
9. To confirm that engine will only start with the propulsion control in the STOP
position, move propulsion control lever
direction away from the STOP position.
10. Make sure no personnel are close to the machine, with the brake applied, turn
the ignition key (12, Figure 4-10) to the Start
not start, verifying that the machine will not start with the propulsion control
lever in a position other than the STOP position.
11. Return ignition switch (12, Figure 4-10) to the STOP
12. Place the propulsion control lever
(center) position.
PROPELLING MACHINE AND OTHER CHECKS/VERIFICATIONS WHILE
ENGINE IS RUNNING.
NOTE: If any controls or devices do not function correctly, do not operate the
machine until the condition(s) is corrected.
1. Press and hold release pushbutton (17, Figure 4-11) and slowly move
propulsion control (19) in desired direction and safe speed of travel as
determined by the conditions. The further the control is moved from the STOP
position the greater the speed in that direction.
4-8
Figure 4-10
(8, Figure 4-10) to verify the horn is operational.
position. The engine should
(19, Figure 4-8) in the STOP
SD-116F/DX/122D/F/DX/160F/DX/190DX/200F/DX
OPERATING INSTRUCTIONS
(19, Figure 4-8) in either
position.