Clean Axle Breathers - Volvo Ingersoll Rand SD-116 TF Series Operator's Manual

MAINTENANCE INSTRUCTIONS
3. Unscrew used fuel filter. Discard used filter in accordance with local guidelines.
4. Clean sealing surface of the filter head (2, Figure 5-63).
5. Fill replacement filter with clean fuel and lubricate new element sealing gasket
(3, Figure 5-63) with clean oil.
6. Install replacement filter as specified by manufacturer. Most filters have
instructions printed on the side.
7. If fuel filter is changed, according to these instructions, no manual bleeding of
fuel lines should be required. If necessary, refer to engine manufacturers
manual for information on bleeding the system.
8. Check for any leaks.

Clean Axle Breathers

1. Thoroughly clean the area around the single axle breathers (1, Figure 5-64)
located on the top of the axle.
2. Remove the single axle breather. It is equipped with a hex area near the base.
3. Cover the breather port to avoid contaminants entering the axle.
4. Thoroughly clean the breather in solvent and dry.
5. Install the breather.
SD-116F/DX/122D/F/DX/160F/DX/190DX/200F/DX
Figure 5-64
SECTION 5
5-55