Volvo Ingersoll Rand SD-116 TF Series Operator's Manual page 152

SECTION 5
3. Remove element (1, Figure 5-62) from filter head (2) and discard according to
local guidelines.
4. Clean sealing surface (2, Figure 5-62) of filter head.
5. Apply a coating of clean oil to the new element sealing gasket.
6. Fill the element with clean fuel.
7. Spin the element onto the filter head according to instructions on element.
8. Start the engine and check for leaks.
Change Fuel Filter Water Separator Element SD-190 and SD-200 TF - Tier III 203
HP Electronic Engine
Fuel is flammable. May cause severe injury or death.
Shut down the engine, extinguish all open flames and do not smoke while
filling the tank.
Always wipe up any spilled fuel.
The engine fuel water separator filter removes water, rust particles, dust and other particles
from the fuel. Use the following procedure to replace the fuel water separator filter (1, Figure
5-63).
1. Clean area around fuel filter (1, Figure 5-63).
2. Place container under the filter to collect any escaping fuel.
5-54
WARNING
!
Figure 5-63
SD-116F/DX/122D/F/DX/160F/DX/190DX/200F/DX
MAINTENANCE INSTRUCTIONS