Alcatel-Lucent 7330 Product Information Manual page 408

NTP 106 — Install an I-010G-B indoor ONT
Safety information
Read the following safety information before installing the unit.
Procedure
Use this procedure to install an I-010G-B indoor ONT.
1
2
3
NTP 106-2
Danger — Observe the local and national laws and regulations that
may be applicable to this installation.
Warning — This equipment is ESD sensitive. Proper ESD protections
should be used when removing the fiber access cover of the indoor ONT.
Caution — Keep indoor ONTs out of direct sunlight. Prolonged
exposure to direct sunlight can damage the unit.
Note — Observe the following:
• The indoor ONT should be installed in accordance with the
applicable requirements of the NEC or CEC. Local authorities and
practices take precedent when there is conflict between the local
standard and the NEC or CEC.
The indoor ONT must be installed by qualified service personnel.
•
Indoor ONTs must be installed with cables that are suitably rated
•
and listed for indoor use.
See I-010G-B detailed
•
temperature ranges for ONTs.
Prepare the cables at the site where the ONT will be installed (DLP 100). Also,
locate the power source where the power converter will be installed.
Are any of the cables missing?
a If yes, go to step 3.
b If no, go to step 4.
Locate each missing cable and route them to the ONT as per local practices.
March 2011
ONT Product Information Guide Edition 01
specificationsin the unit data sheet for the
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
3FE 54199 AAAA TCZZA