Alcatel-Lucent 7330 Product Information Manual page 273

Security
The HTTP and CLI interfaces are password-protected to prevent unauthorized access
to utilities. In addition, each ONT has a security setting that specifies the access level
of a user to the HTTP and CLI interface utilities, after the ONT is ranged. User access
levels are as follows:
•
read-write access, which grants a user read and write access to all utilities
•
read-only access, which grants a user read-only access to the SLID, ranging state,
and RSSI of the ONT
•
no access, which denies a user access to all utilities
HTTP interface
The HTTP interface is GUI-based. Figure
the main parts of the interface labeled. The following sections describe these parts.
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
3FE 54199 AAAA TCZZA
Note 1 —
Contact the CO for the level of access that has been set for
a specific ONT.
Note 2 —
The HTTP and CLI interfaces require a specific username
and password. Contact your Alcatel-Lucent technical support
representative for username and password information.
Note 3 —
The following exceptions apply to security.
•
If the PON is out of service, you have read-only access to the
SLID, ranging state, and RSSI of the ONT, regardless of the access
level of the ONT.
•
If the ONT or the Ethernet port on the ONT is out of service, you
cannot log in to the ONT using the HTTP or CLI interface.
Edition 01 ONT Product Information Guide
6 — ONT management using an ONT interface
6-1 shows a sample HTTP interface, with
March 2011 6-5