Alcatel-Lucent 7330 Product Information Manual page 390

NTP 104 — Replace an I-010G-A indoor ONT
Procedure
Use this procedure to replace an I-010G-A indoor ONT.
1
2
3
4
5
6
7
8
9
NTP 104-2
Deactivate the ONT services (DLP 124). If you are using the SLID feature, this step
is not required. The ONT and the services can remain in service (IS).
At the subscriber site, remove the ONT from its wall mount (if applicable) and
disconnect the power and Ethernet cables; see Figure
Figure NTP 104-1: I-010G-A indoor ONT with cabling
SC/APC
connector
Disconnect the SC/APC fiber optic cable from the I-010G-A indoor ONT.
Danger — Fiber optic cables transmit invisible laser light. To avoid eye
damage or blindness, never look directly into fibers, connectors, or
adapters.
Replace the I-010G-A indoor ONT with a new unit.
Reattach the power and Ethernet cables to the ONT.
Reconnect the power cable to the power converter and then the electrical outlet.
Verify that the unit is powered. If there is no power, press the On/Off button.
If used, configure the SLID (DLP 122).
Note — A new SLID or the old SLID may be used with the replacement
ONT. If a new SLID is used, the new SLID must also be programmed at
the P-OLT using TL1 or a network manager. If the old SLID is used, no
changes need to be made at the P-OLT; see the operations and
maintenance documentation for the OLT for more details.
If required, have approved service personnel who are trained to work with optic
fiber clean the fiber optic connection. See DLP
fiber optic handling, inspection, and cleaning.
Danger — Fiber optic cables transmit invisible laser light. To avoid eye
damage or blindness, never look directly into fibers, connectors, or
adapters.
March 2011
ONT Product Information Guide Edition 01
Ethernet (GE)
RJ-45
127 for more information about
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
NTP 104-1.
Power
connector
19836
3FE 54199 AAAA TCZZA