Alcatel-Lucent 7330 Product Information Manual page 329

Procedure 6-42 To clear the SLID
1
2
3
4
Procedure 6-43 To enter the SLID
1
2
3
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
3FE 54199 AAAA TCZZA
Perform one of the following:
a If you are using an Ethernet port, ensure that the ONT is disconnected from
the PON optical cable.
b If you are using a craft port, you can clear the SLID with the ONT connected
to or disconnected from the PON optical cable.
Choose option 5, Clear SLID, from the
The ONT sets the SLID to the default value, and the following message appears:
SLID cleared successfully!
Choose option 4, Retrieve SLID from the main menu to verify that the SLID is reset
to its default value.
STOP. This procedure is complete.
Perform one of the following:
a If you are using an Ethernet port, ensure that the ONT is disconnected from
the PON optical cable.
b If you are using a craft port, you can enter the SLID with the ONT connected
or disconnected from the PON optical cable.
Choose option 4, Retrieve SLID, from the
to DEFAULT or null.
Perform one of the following from the main menu
a Choose option 1, Enter SLID in volatile mode, to enter a volatile SLID.
b Choose option 2, Enter SLID in permanent mode, to enter a non-volatile
SLID delivered in proprietary mode.
c Choose option 3, Enter SLID in registration mode, to enter a non-volatile
SLID delivered in registration ID mode.
The following appears:
Enter Subscriber Location Id
> ALPHANUMERIC MODE (Length(1..10)):
> HEX MODE (Length(1..20))
> Note: FOR HEX MODE -- APPEND THE VALUE WITH 0x
Edition 01 ONT Product Information Guide
6 — ONT management using an ONT interface
Main menu
Main menu
March 2011
to clear the SLID.
to ensure that the SLID is set
6-61