Alcatel-Lucent 7330 Product Information Manual page 251

Parameter Description
direction_in_hold_r This parameter controls the value
eq of direction attribute inserted into
the hold SDP when standard hold
behavior is enabled. This
parameter is ignored when the
obsolete_hold parameter is
enabled. The options are
"sendonly" (default) and
"inactive", which correspond to
the direction attribute that is used
in SDP for the hold request.
etsi_ch_release_hel This parameter contains the
d_call service code to be used to release
the held session during a
consultation call. If this property is
not configured or is configured to
contain the empty string, the ONT
shall disable this functionality.
Valid values shall be of the form
"Rd", where d represents '0'-'9' or
'*' or '#'. An invalid value will cause
the ONT to act as if this parameter
was not configured. This
parameter only has meaning if the
enable_esti parameter is set to
"yes". The default is an empty
string.
etsi_activate_call_ A set of one or more service codes
that the user agent will recognize
waiting
as a request to activate call
waiting in ETSI mode. The value of
this property may include up to
two service codes of six characters
each, separated by white space.
This reflects that fact that in
typical dial plans there are two
equivalent ways to dial a given
service code. The default is
"*43#".
etsi_deactivate_call A set of one or more service codes
_waiting that the user agent will recognize
as a request to de-activate call
waiting in ETSI mode. The value of
this property may include up to
two service codes of six characters
each, separated by white space.
This reflects that fact that in
typical dial plans there are two
equivalent ways to dial a given
service code. The default is
"#43#".
(19 of 23)
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
Mode Mode Device
1 2
N Y All
except
package
C, D,
and E
N Y All
except
package
C, D,
and E
N Y All
except
package
C, D,
and E
N Y All
except
package
C, D,
and E
March 2011
5 — VoIP overview
OMCIv2 TL1 or CLI
support? parameters
No, value is N/A
derived
from
FTP/default
line profile.
No, value is N/A
derived
from
FTP/default
line profile.
No, value is N/A
derived
from
FTP/default
line profile.
No, value is N/A
derived
from
FTP/default
line profile.
5-51