NTP 104 — Replace an I-010G-A indoor
Purpose
This DLP provides the steps to replace an I-010G-A indoor ONT.
General
You must issue TL1 commands at the P-OLT before you replace an I-010G-A indoor ONT
at the subscriber site, and again before you can verify the subscriber services.
Prerequisites
The prerequisites are:
network management access or craft port access to the P-OLT that supports the
•
I-010G-A indoor ONT to be replaced.
serial number of the replacement I-010G-A indoor ONT.
•
Ensure that any debugging sessions are disabled. You can re-enable debugging after
•
the procedure is complete.
For information about TL1 command syntax, see the operations and maintenance
documentation for the OLT.
Required tools
The required tools are:
wire strippers
•
•
#2 Phillips screwdriver
fiber optic splicing tools
•
RJ-45 cable plug crimp tool
•
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
3FE 54199 AAAA TCZZA
ONT
Edition 01 ONT Product Information Guide
March 2011
NTP 104-1