Alcatel-Lucent 7330 Product Information Manual page 249

Parameter Description
etsi_cw_merge This parameter contains the
service code to be used to merge
the 2-call waiting sessions and
transition into a 3-way call with
mixing in the ONT. If this property
is not configured or is configured
to contain the empty string, the
ONT disables the merge sessions
operation for the line in question.
Valid values are in the form "Rd,
where d represents '0'-'9' or '*' or '#'.
An invalid value causes the ONT to
act as if this parameter was not
configured. This parameter only
has meaning if the enable_esti
parameter is set to "yes". The
default is an empty string.
cw_alert_timer This parameter specifies the value,
in seconds, of the duration for
which the user is allowed to
answer a call waiting call. The
default is 120 seconds.
enable_dead_line_t This parameter controls ONT
one behavior with respect to playing a
"dead line tone" when the user
goes off-hook and either:
•
•
•
The default is "no", indicating that
no tone is output in either case.
enable_reverse_pola This parameter controls whether
rity reverse polarity is used.
This parameter can be configured
only when the enable_etsi
parameter is set to yes. It must be
configured for each line. When
enabled:
For the originator of a call, polarity
is reversed when the call is
answered (200 OK received). For
the terminator of a call, polarity is
reversed prior to the start of
ringing.
For either the originator or
terminator, when the call ends
because BYE received, normal
polarity is resumed. For the
originator, if the user goes
on-hook, normal polarity is
resumed. For the terminator, if the
user goes on-hook, reverse polarity
continues until the re-answer
timer expires, then normal polarity
is resumed.
The default is "no". Set to "yes" to
enable reverse polarity.
(17 of 23)
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
3FE 54199 AAAA TCZZA
the line is unregistered
the PON is unavailable
addressing could not be
obtained from the DHCP server
Edition 01 ONT Product Information Guide
Mode Mode Device
1 2
N Y All
except
package
C, D,
and E
N Y All
except
package
C, D,
and E
Y Y All
except
package
C, D,
and E
N Y All
except
package
C, D,
and E
March 2011
5 — VoIP overview
OMCIv2 TL1 or CLI
support? parameters
No, value is N/A
derived
from
FTP/default
line profile.
No, value is N/A
derived
from
FTP/default
line profile.
No, value is N/A
derived
from
FTP/default
line profile.
No, value is N/A
derived
from
FTP/default
line profile.
5-49