Alcatel-Lucent 7330 Product Information Manual page 285

5
6
7
Procedure 6-9 To disconnect from the CLI interface
1
2
3
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
3FE 54199 AAAA TCZZA
Perform one of the following:
a To connect the ONT using an Ethernet port and cable to a computer or
laptop, start a Telnet session by typing
telnet 192.168.1.x↵
Note — Any three digits can supply the last segment of the 192.168.1.x
IP address. For example, 192.168.1.100 is a valid IP address.
b To connect the computer or laptop to the ONT using a Telnet client, start a
Telnet session by typing
telnet 192.168.1.251↵
Note — NetTerm is the recommended Telnet client.
Log in to a Telnet session:
<L>ogin
User Name:CRAFTSPERSON
Password:ALC#FGU
where
User Name is the username for the ONT
Password is the password for the ONT
The SLID menu appears.
STOP. This procedure is complete.
Type X or x for Exit from the
Perform one of the following:
a If you are connected to the CLI interface through a craft port, disconnect the
serial cable from the RS-232 connector.
b If you are connected to the CLI interface through an Ethernet port,
disconnect the Ethernet cable from the Ethernet port.
STOP. This procedure is complete.
Edition 01 ONT Product Information Guide
6 — ONT management using an ONT interface
SLID menu at any time during the session.
March 2011 6-17