Alcatel-Lucent 7330 Product Information Manual page 255

Parameter Description
service_code_disabl Specifies the feature access
e_warm service code used by subscriber to
deactivate warmline. The user
agent must support at least two
service codes, as is typical in most
dialing plans. The default is #53#.
This reflects that fact You can
configure the parameter when the
enable_warmline parameter is set
to Subscriber.
osi_timer Specifies the open switch interval
duration. The option is a number
from 0 to X, which represents
milliseconds. The default is 900.
When set to 0, the ONT starts the
permanent signal treatment
immediately after the release
timer expires after a BYE is
received for an incoming/outgoing
call.
When set to non-zero, then after
release timer expires, the ONT
removes the loop current for the
specified time and then starts the
permanent signaling treatment.
(23 of 23)
Note
(1) The default value of the parameter outbound_uri_prefix is "sip" and not "tel". If necessary, change the configuration of
the value to "tel".
5.7 Digit map
A digit map is used to control how the ONT or MDU processes dialed digits for a
voice service.
Besides simple collection of the digits of a phone number, it allows for ONT or MDU
internal handling of special dialed sequences like 911 and service codes. The ONT
utilizes the configured digit map at call origination, or in some cases after flash-hook.
In SIP mode 1, there is no digit collection by the ONT after flash-hook. In SIP mode
2, digit collection is usually started after a mid-call flash-hook. In all other cases
digits are simply passed in-band in the voice path, either as tones or as RFC 2833
packets. The digit map also allows for these subscriber interaction functions:
•
timeout of digit collection
•
termination of digit collection
•
output of recall dial tone or normal dial tone
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
Mode Mode Device
1 2
N Y All
except
package
C, D,
and E
N Y All
except
package
C, D,
and E
March 2011
5 — VoIP overview
OMCIv2 TL1 or CLI
support? parameters
No, value is N/A
derived
from
FTP/default
line profile.
No, value is N/A
derived
from
FTP/default
line profile.
5-55