Alcatel-Lucent 7330 Product Information Manual page 325

Procedures using HTTP interface
The following procedures provide the steps to view the current SLID settings, to
clear the SLID, and to enter the SLID at the ONT using the HTTP interface.
Procedure 6-38 To view the current SLID settings
1
2
3
Procedure 6-39 To clear the SLID
1
2
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
3FE 54199 AAAA TCZZA
Note 1 —
To enter or clear a SLID using an Ethernet connection, the
ONT must be disconnected from the PON optical cable.
Note 2 —
You cannot change the SLID settings when the ONT is
connected, ranged, and provisioned.
From the Web-Management System window, click on the SLID Management tab,
as shown in Figure 6-32.
Figure 6-32 Main options in the Web-Management System window
The SLID window opens with the current SLID settings, as shown in Figure 6-33.
where the SLID settings are described in Table
Click on the Refresh button to refresh the contents of the window.
STOP. This procedure is complete.
Ensure that the ONT is disconnected from the PON optical cable.
From the SLID window, click on the Clear button to reset the SLID to its default
settings.
Edition 01 ONT Product Information Guide
6 — ONT management using an ONT interface
Figure 6-33 SLID window
6-10
March 2011 6-57