Alcatel-Lucent 7330 Product Information Manual page 327

3
4
5
6
7
8
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
3FE 54199 AAAA TCZZA
Enable one of the following radio buttons to set the Mode of the SLID:
• Volatile—In volatile mode, the SLID at the ONT returns to its default value
after the ONT is powered off and on. A volatile SLID is always delivered to the
P-OLT in the proprietary mode, which uses the proprietary PLOAM message.
Permanent—In permanent mode, the SLID at the ONT is stored in non-volatile
•
mode, and is delivered to the P-OLT in proprietary mode, which uses the
proprietary PLOAM message. A non-volatile SLID retains its configured value
after the ONT is powered off and on.
• Registration—In registration mode, the SLID at the ONT is stored in
non-volatile mode, and is delivered to the P-OLT in registration ID mode, which
uses the password PLOAM message defined in G.984.3. A non-volatile SLID
retains its configured value after the ONT is powered off and on.
Enable one of the following radio buttons to set the String format:
Hexadecimal—20 characters of 0 to 9 and usually a to f or, A to F, with zeroes
•
appended to a length of 20 characters
Alphanumeric—up to 10 ASCII characters
•
Note — The default value is alphanumeric.
Type the SLID in the SLID Value box.
Click on the Apply button to apply the SLID to the ONT. The Set SLID dialog box
opens, as shown in Figure 6-36.
Figure 6-36 Set SLID dialog box
Click on Yes to set the SLID to its new value.
The status bar displays the message "The slid setting has been applied!".
Connect the PON optical cable to the ONT.
Edition 01 ONT Product Information Guide
6 — ONT management using an ONT interface
March 2011 6-59