Alcatel-Lucent 7330 Product Information Manual page 417

9
10
11
12
13
14
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
3FE 54199 AAAA TCZZA
Figure NTP 107-3: Molex 8-pin connector
Pin 2 Pin 8
Pin 1 Pin 3 Pin 7
Power up the ONT unit by using the ON/OFF power switch.
If necessary, reset the ONT (DLP 119).
If used, configure the SLID (DLP 122).
Note — A new SLID or the old SLID may be used with the replacement
ONT. If a new SLID is used, the new SLID must also be programmed at
the P-OLT using TL1 or a network manager. If the old SLID is used, no
changes need to be made at the P-OLT; see the appropriate P-OLT
Operations and Maintenance Procedures Guide for more details.
Verify the ONT LEDs and voltage status (DLP 120).
Activate and test the services (DLP 121).
STOP. This procedure is complete.
Edition 01 ONT Product Information Guide
NTP 107 — Replace an I-010G-B indoor ONT
March 2011
20179
NTP 107-5