Alcatel-Lucent 7330 Product Information Manual page 242

5 — VoIP overview
Parameter Description
obsolete_hold Indicates whether the user agent
must use the obsolete hold
convention (a connection address
of 0.0.0.0) when placing a media
stream on hold. This is a string
containing a value of "yes" or
"no." The default value is "yes."
session_timer_min The minimum acceptable value for
the RFC 4028 session timer
interval. This is a non-negative
integer. The value is expressed in
seconds. The default value is 90,
which is the RFC 4028 absolute
minimum.
session_timer_max The RFC 4028 session timer
interval to be proposed by the user
agent. This is a non-negative
integer. The value is expressed in
seconds. The default value is 1800,
which is the RFC 4028
recommended value.
session_timer_refres Specifies the refresher to be
her specified by the user agent when it
has a choice. A value of "none"
specifies that the user agent will
not request session expiration. Any
other value specifies that the user
agent will request session
expiration. This is a string
containing either "none," "uas,"
or "uac." The default value is
"uas."
cid_allows_from_hd A value specifying whether
r information from the FROM header
may be used in providing caller ID
to the phone set. Information from
P-Asserted-Identity header is
always used in preference to the
FROM header. This value only has
effect when no P-Asserted-Identity
information is available. A "yes"
means that the FROM header will
be used for the caller ID if the
P-Asserted-Identity header is not
present in the INVITE message. A
"no" means that, if the
P-Asserted-Identity header is not
present, then no caller ID is
provided to the phone set. The
default value is "no".
enable_caller_id The same as the
cid_allows_from_hdr parameter
(10 of 23)
5-42
Mode Mode
1 2
N Y
Y Y
Y Y
Y Y
Y Y
Y Y
March 2011 Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
ONT Product Information Guide Edition 01
Device OMCIv2 TL1 or CLI
support? parameters
Package No, value is N/A
A, B, H derived
only from
FTP/default
line profile.
Package No, value is N/A
A, B, H derived
only from
FTP/default
line profile.
Package No, value is N/A
A, B, H derived
only from
FTP/default
line profile.
Package No, value is N/A
A, B, H derived
only from
FTP/default
line profile.
Package No, value is N/A
A, B, H derived
only from
FTP/default
line profile.
Package No, value is N/A
C, D, E, derived
F, and G from
FTP/default
line profile.
3FE 54199 AAAA TCZZA