Alcatel-Lucent 7330 Product Information Manual page 386

NTP 103 — Install an I-010G-A indoor ONT
5
6
NTP 103-4
Place the I-010G-A indoor ONT unit:
a On a flat surface, such as a desk, horizontally resting on its four plastic feet
(as shown in Figure
Figure NTP 103-1: I-010G-A indoor ONT mounted on a flat surface
b On a wall by sliding the I-010G-A indoor ONT unit over mounting screws.
i Measure and drill two holes 11 cm (4.3 in) apart in the wall where the
ONT will be mounted. The holes should be the same distance apart as
the holes molded into the back of the ONT enclosure; as shown in
Figure NTP 103-2.
Figure NTP 103-2: Location of wall mount holes on the I-010G-A indoor ONT
ii Attach the mounting screws in the wall.
iii Slide the wall mounting holes on the ONT down over the mounting
screws until the ONT is securely seated.
Connect the ac power cable to the power converter, and plug the power converter
into the electrical outlet; see Figure
March 2011
ONT Product Information Guide Edition 01
NTP 103-1); go to step 6.
NTP 103-3.
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
19834
Wall mount holes
19832
3FE 54199 AAAA TCZZA