Alcatel-Lucent 7330 Product Information Manual page 253

Parameter Description
etsi_held_party_ring This parameter shall control
back whether or not ringing shall be
applied when a user goes on hook
with an RTP session on hold. This
parameter only applies when the
enable_esti parameter is set to
true. The default is "no".
etsi_ch_release_earl Specifies the code used to release
iest a call and return to a two-way call
by releasing the first added call.
Valid values are in the form Rd,
where d is 0-9, *, or #. The default
is an empty string. You can only
configure the parameter when the
enable_etsi parameter is set to
true.
etsi_ch_release_late Specifies the code used to release
st a call and return to a two-way call
by releasing the last added call.
Valid values are in the form Rd,
where d is 0-9, *, or #. The default
is an empty string. You can only
configure the parameter when the
enable_etsi parameter is set to
true.
etsi_3wc_release_ea Specifies the code used to reduce a
rliest three-way call to a two-way call by
releasing the first added call. Valid
values are in the form Rd, where d
is 0-9, *, or #. The default is an
empty string. You can only
configure the parameter when the
enable_etsi parameter is set to
true.
etsi_3wc_release_la Specifies the code used to reduce a
test three-way call to a two-way call by
releasing the last added call. Valid
values are in the form Rd, where d
is 0-9, *, or #. The default is an
empty string. You can only
configure the parameter when the
enable_etsi parameter is set to
true.
(21 of 23)
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
Mode Mode Device
1 2
N Y All
except
package
C, D,
and E
N Y All
except
package
C, D,
and E
N Y All
except
package
C, D,
and E
Y Y All
except
package
C, D,
and E
Y Y All
except
package
C, D,
and E
March 2011
5 — VoIP overview
OMCIv2 TL1 or CLI
support? parameters
No, value is N/A
derived
from
FTP/default
line profile.
No, value is N/A
derived
from
FTP/default
line profile.
No, default N/A
value is used
in TL1.
No, value is N/A
derived
from
FTP/default
line profile.
No, value is N/A
derived
from
FTP/default
line profile.
5-53