NTP 100 — Install a B-0404-A
NTP 100-4
Figure NTP 100-2: B-0404-A in a stand mount
iii
Go to step 6.
c
In a wall mount bracket.
i
Measure and drill two holes in the wall where the ONT will be mounted.
The holes should be the same distance apart as the holes on the wall
mounting bracket (83.3 mm apart, or 3.28 in).
ii
Align the holes in wall mount bracket with the holes in the wall.
iii
Fasten the wall mount bracket to the wall with either screws or bolts.
iv
Slide the ONT down over the mounting bracket until the fiber optic port
is directly in front of the fiber optic port cable lead built into the
bracket, as shown in Figure
March 2011
ONT Product Information Guide Edition 01
NTP
100-3.
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
19869
3FE 54199 AAAA TCZZA