Alcatel-Lucent 7330 Product Information Manual page 221

Parameter Description
transport_pr The name (UDP, TCP, TLS) of the
otocol (1) transport protocol and the port
number to be used for signaling. This is
an optional parameter, the default
protocol value is UDP and the default
port number is 5060. UDP is the only
allowed value for transport protocol.
(This parameter does not apply to
iConfig message transport.)
For package C and D ONTs, UDP is used
without any configuration necessary.
registrar_uri The uniform resource identifier (URI) is
(1)
used as the request URI for all
REGISTER requests. This is a string of
up to 99 characters and is a required
parameter. The FTP XML name of this
parameter is shown as RegistrarURI.
Can use the form sip:domain or
sip:registrar_route
registrar_ro The address of the server or proxy to
ute (1) which REGISTER requests are sent. It is
a numeric IP address or a fully qualified
domain name. This is a string of up to
99 characters and is a required
parameter. The FTP XML name of this
parameter is shown as RegistrarRoute.
When the string dhcp is used, this
keyword substitutes the IP address or
domain name returned from DHCP
option 120 instead of the
registrar_route parameter value. If the
DHCP server does not provide an option
120 value, a 0.0.0.0 address is
substituted and a registration failure
alarm is raised for each configured
POTS line.
Can use the form xxx.xxx.xxx.xxx:port,
where xxx.xxx.xxx.xxx is the IP address
and port is the port number from
transport_protocol
register_per The registration expiration time that
(1)
iod the client will propose by including it in
an Expires header of a REGISTER
request. This is a non-negative integer
and the value is expressed in seconds.
The default value is 3600.
(1 of 4)
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
3FE 54199 AAAA TCZZA
Table 5-8 SIP protocol parameters
Edition 01 ONT Product Information Guide
Mode Mode Device
1 2
Y Y Package
A, B, H
only
Y Y All
except
package
C and D
Y Y All
Y Y All
March 2011
5 — VoIP overview
OMCIv2 TL1 and CLI
support? parameters
Yes TL1 using UDPPort
Default is using
UDP ent-ontsip-config
CLI using udp-port
using configure
voice ont
sip-config
Yes TL1 using
PROXYSERVPROFID
using
ent-ontsip-config
CLI using
proxyserv-prof
using configure
voice ont
sip-config
Yes, but TL1 using
registrar REGISTRARPROFID
address and
and REGISTRARPROFN
registrar M using
route will ent-ontsip-config
have the
CLI using
same
registrar-prof
address.
using configure
voice ont
sip-config
Yes TL1 using
REGEXPTIME using
ent-ontsip-config
CLI using
reg-expire-time
using
configure voice
ont sip-config
5-21